Diagnostic Procedure
- Ensure stoplights illuminate when brake pedal is depressed, and turn off when released. If operation is as specified, go to next step. If operation is not as specified, repair stoplight circuit. See WIRING DIAGRAMS .
- Disconnect ABS ECU harness connector. Using DVOM, measure voltage between chassis ground and terminal No. 5 (Green/White wire) at ABS ECU harness connector. See Figure. Depress brake pedal. If voltage is 8-14 volts, replace ABS actuator assembly. See ABS ACTUATOR/ECU under REMOVAL & INSTALLATION. If voltage is not 8-14 volts, go to next step.
- Check for open circuit in wiring harness between ABS ECU and stoplight switch. See WIRING DIAGRAMS . Repair as necessary. If no problem is found, perform next logical circuit check listed in SYMPTOM DIAGNOSIS . See SYMPTOM DIAGNOSIS under TROUBLE SHOOTING.