Diagnostic Procedure
Turn ignition on. Measure voltage between terminals Ts and E1 of DLC1 (or terminals Tc and CG of DLC3). If voltage is 10-14 volts, circuit is okay. If ABS warning light does not blink even after terminals are connected, malfunction may exist in ABS/TRAC ECU. If voltage is not 10-14 volts, check for open or short circuit in wiring harness between ABS/TRAC ECU harness connector A15 terminal No. 23 and DLC1 or DLC3, or between ground and DLC1 or DLC3. See WIRING DIAGRAMS . Repair as necessary. If wiring harness is okay, replace ABS/TRAC ECU. See ABS/TRAC ECU under REMOVAL & INSTALLATION.