LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1999 >> RAV4 Base, 4D Utility, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (A/C-Heater System) >> Testing >> Thermistor

Section 5 (A/C-Heater System): Testing: Thermistor

WARNING: This page is about a different car, the 1998 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable and wait at least 90 seconds. Remove lower trim panel and glove box. Disconnect thermistor 2-pin connector from top of evaporator case. See Fig 1. Measure resistance of thermistor while still installed.
  2. Resistance should be 1500 ohms at 77°F (25°C) ambient temperature. If resistance is not within specification, replace thermistor. If resistance is as specified, go to next step.
  3. Remove evaporator case. See EVAPORATOR ASSEMBLY  under REMOVAL & INSTALLATION. Disassemble evaporator case and remove thermistor. Check thermistor operation. Submerge thermistor at least 3.94" (100 mm) deep in cold water. See Fig 2.
  4. Place thermometer in water and measure resistance of thermistor at various temperatures. Use ice or hot water to vary water temperature. If readings are not within specification, replace thermistor. See THERMISTOR RESISTANCE VALUES  table.
THERMISTOR RESISTANCE VALUES

Water Temperature °F (°C) Ohms
41 (5) 3500-4050
39 (4) 3800-4300
37 (3) 3900-4500
36 (2) 4100-4800
34 (1) 4300-4900
32 (0) 4500-5200
Fig 1: Identifying Thermistor Connector Terminals
G95H60449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Testing Thermistor
G95J60466Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002