LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1999 >> RAV4 Base, 4D Utility, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (A/C-Heater System) >> Testing >> A/C Switch

A/C Switch

WARNING: This page is about a different car, the 1998 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable and wait at least 90 seconds. Remove glove box and lower instrument finish panel. Disconnect control cables. Remove A/C switch. Disconnect wire harness connector. Check continuity at specified terminals. See Fig 1. Also, see the A/C SWITCH CONTINUITY  table. A/C switch has a diode, check continuity in both directions before replacing switch.

A/C SWITCH CONTINUITY

Switch Position Continuity Between Terminal No.
OFF (1)
ON 5 & 6
(1) With A/C switch in either position, continuity should exist between terminals No. 1 and 3 for A/C switch illumination. With A/C switch off, continuity should not exist between any other terminals.
Fig 1: Identifying A/C Switch Terminals
G95F60462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002