LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1999 >> RAV4 Base, 4D Utility, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (A/C-Heater System) >> Testing >> A/C Amplifier

A/C Amplifier

WARNING: This page is about a different car, the 1998 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable and wait at least 90 seconds. Disconnect A/C amplifier connector. A/C amplifier is located on top of A/C cooling unit (evaporator housing) behind glove box. Test wire harness side of connector. See Fig 1. Ensure circuit tests as specified in A/C AMPLIFIER CIRCUIT TEST  table. If circuits DO NOT  test as specified, repair as necessary.

A/C AMPLIFIER CIRCUIT TEST

Terminal No. & Test Condition (1) Specification
5 & Ground Continuity
14 & 13 (2) 115 Ohms
9 & 13 (2) 1500 Ohms
8 & Ground
A/C Switch ON Battery Voltage
A/C Switch OFF No Voltage
12 & Ground Battery Voltage
10 & Ground
A/C Switch ON Less Than 4 Volts
A/C Switch OFF No Voltage
Defrost Position Battery Voltage
2 & Ground (3) Battery Voltage
(1) Ensure ignition switch is on, temperature control lever is at the maximum cool position, and blower switch is on HI position.
(2) Test with air temperature at 68°F (20°C).
(3) Connect A/C amplifier connector. Turn ignition on, temperature control to maximum cooling and blower to high speed. Backprobe between connector terminal No. 2 and ground. There should be no battery voltage when system pressures are less than 28 psi (2 kg/cm2 ) or greater than 455 psi (32 kg/cm2 ).
Fig 1: Identifying A/C Amplifier Connector Terminals
G95H60951Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002