LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1999 >> RAV4 Base, 4D Utility, AWD, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing - 4-Cylinder >> Engine Sensors & Switches >> Throttle Position Sensor >> RAV4

Throttle Position Sensor: RAV4

  1. Note location of E2 terminal (Brown wire), VC terminal (Yellow wire) and VTA terminal (Blue/Red wire) on TP sensor. Ensure ignition is off. Disconnect electrical connector from Throttle Position (TP) sensor on throttle body. Disconnect vacuum hose and apply vacuum to throttle opener.
  2. Using ohmmeter, check resistance between specified terminals in relation to throttle position. See TP SENSOR RESISTANCE SPECIFICATIONS  table. Replace components as necessary if resistance is not within specification.
TP SENSOR RESISTANCE SPECIFICATIONS

Throttle Position Terminals Ohms
Fully Closed VTA & E2 200-5700
Fully Open VTA & E2 2000-10,200
VC & E2 2500-5900
Fig 1: Identifying Terminals For Testing Throttle Position (TP) Sensor (Camry & Camry Solara)
G98F11226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Identifying Terminals For Testing Throttle Position (TP) Sensor (Celica)
G97I06256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 3: Identifying Terminals For Testing Throttle Position (TP) Sensor (Corolla)
G98G11227Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 4: Identifying Terminals For Testing Throttle Position (TP) Sensor (Tacoma & 4Runner)
G97A06281Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002