Valve Clearance: Tercel
- Disconnect spark plug wires from spark plugs. Disconnect electrical connectors at ignition coils. Remove bolts and ignition coils from valve cover. Disconnect PCV hose from valve cover.
- Remove valve cover nuts, seal washers, valve cover and gasket. Rotate crankshaft clockwise (viewed from timing belt end of engine) until timing mark (groove) on crankshaft pulley aligns with "0" mark on timing belt cover and cylinder No. 1 is at TDC on compression stroke. Cylinder No. 1 is the front cylinder at timing belt end of engine.
- Ensure valve lifters on cylinder No. 1 are loose and valve lifters on cylinder No. 4 are tight. If valve lifters are not as specified, rotate crankshaft clockwise one full revolution (360 degrees) and realign crankshaft pulley timing mark with "0" mark on timing belt cover.
- With cylinder No. 1 at TDC on compression stroke, use feeler gauge to measure valve clearance between valve lifter and camshaft on specified valves. Perform STEP 1. See Fig 1. Record valve clearance.
- To check remaining valves, rotate crankshaft clockwise one full revolution (360 degrees) and realign crankshaft pulley timing mark with "0" mark on timing belt cover. Using feeler gauge, measure valve clearance on specified valves. Perform STEP 2. See Fig 1. Record valve clearance.
- Ensure valve clearance is within specification. See VALVE CLEARANCE SPECIFICATIONS (TERCEL) table.VALVE CLEARANCE SPECIFICATIONS (TERCEL)
Application (1) In. (mm) Intake .006-.010 (.15-.25) Exhaust .012-.016 (.31-.41) (1) Adjust valve clearance with engine cold. - If valve clearance requires adjustment, rotate crankshaft so camshaft lobe on valve to be adjusted is facing upward, away from valve lifter. Rotate valve lifter so notch on valve lifter is toward spark plug.
- Valve Clearance Adjuster (SST 09248-55040) is to remove adjusting shim. Using SST "A" of valve clearance adjuster, press valve lifter downward. See Figure. Install SST "B" between camshaft and valve lifter with side marked with No. 9 at designated position. See Figure. Remove SST "A".
- Using small screwdriver and magnet, remove adjusting shim. Using micrometer, measure thickness of adjusting shim removed. Using measured clearance and adjusting shim thickness, determine correct thickness of adjusting shim to be used. See Fig 3 and Fig 4. Install replacement adjusting shim. Recheck valve clearance.
- Before installing valve cover and gasket, apply sealant at specified areas on cylinder head. See Fig 2. Install gasket, valve cover, seal washers and valve cover nuts. Tighten valve cover nuts to specification. See TORQUE SPECIFICATIONS .
- To install remaining components, reverse removal procedure. Tighten ignition coil bolts to specification. See TORQUE SPECIFICATIONS .