LEMON Manuals: Even more car manuals for everyone

DTC 41: Power Source Circuit: Testing

  1. Ensure battery voltage is 10-14 volts. Repair battery and/or charging system if necessary.
  2. Remove ABS ECU with connectors still connected. Turn ignition on. Check voltage by backprobing ECU connector terminals. See POWER SOURCE TERMINAL IDENTIFICATION table. If 10-14 volts does not exist, go to next step. If 10-14 volts exists, perform appropriate ECU pin voltage test under PIN VOLTAGE.
    POWER SOURCE TERMINAL IDENTIFICATION

    ECU Power Connector/Terminal ECU Ground Connector/Terminal
    Non-Turbo
    A18/2 A19/2 & A19/13
    Turbo
    A20/13 A20/12 & A20/25
  3. Check resistance between ECU ground terminals and a good ground. See POWER SOURCE TERMINAL IDENTIFICATION  table. If resistance is one ohm or less, go to next step. If resistance is more than one ohm, repair wiring or connection to ground.
  4. Remove ECU-IG fuse from junction block No. 1. Check fuse and connections. Repair and/or replace if necessary. If fuse is okay, check for open circuit between battery and ABS ECU. If fuse is faulty, check for short circuit in wiring protected by ECU-IG fuse. Repair as necessary.