Turned On
- Remove short pin from DLC1. Connect DLC1 terminal WA on harness (female) side to ground. Turn ignition on. If ABS light comes on, go to next step. If ABS light does not come on, replace ABS bulb, or repair open circuit between ABS light and GAUGE fuse (Yellow wire), or ABS light and DLC1 WA terminal (Orange wire).
- Turn ignition off. Unplug ABS ECU connector. Connect ABS ECU connector terminal "W" (Orange wire) on wire harness side to ground. Turn ignition on. If ABS light comes on, go to next step. If ABS light does not come on, repair open circuit between ABS ECU connector terminal "W" (Orange wire) and splice at cowl harness behind instrument cluster.
- Turn ignition off. Unplug ABS control relay connector. Connect ABS control relay connector terminal "W" (Red/Blue wire) and ground. See Figure. Turn ignition on. If ABS light comes on, go to next step. If ABS light does not come on, repair open circuit between ABS control relay connector terminal "W" (Red/Blue wire) and DLC1.
- Turn ignition off. Using ohmmeter capable of testing diodes, check for continuity between terminal "W" and ground (GND) on control relay. See Figure. Reverse ohmmeter leads. Again check for continuity.
- If continuity exists with ohmmeter connected only one way, replace ABS ECU, then retest system. If continuity exists with ohmmeter connected both ways, or continuity does not exist at all, see ABS CONTROL RELAY under COMPONENT TESTING.
- If short in ABS control relay diode exists, a malfunction at ABS ECU terminal "W" (Orange wire) will occur. When inspecting terminal, reconnect ABS wiring. Unplug control relay connectors and DLC1. Turn ignition on. If ABS light comes on, ABS ECU terminal "W" (Orange wire) is okay.