LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> Land Cruiser >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Actuator Check

Actuator Check

NOTE: Actuator Checker (09990-00150) is required to perform ACTUATOR CHECK .
  1. Ensure battery voltage exists. Turn ignition off. Unplug actuator electrical connector. Remove control relay from actuator bracket. Disconnect control relay electrical connectors. Connect Test Harness (09990-00200 and 09990-00210) and Actuator Checker (09990-00150) to vehicle, following manufacturer's instructions. Connect actuator checker positive and negative power cables to vehicle battery.
  2. Start and idle engine. Set actuator checker selector switch to FRONT RH position. Press and hold SUB MOTOR switch for a few seconds. Press and hold brake pedal.
    NOTE: DO NOT  press ON/OFF switch for more than 10 seconds.
  3. Press ON/OFF switch. When ON/OFF switch is pressed, brake pedal should not go down. Release ON/OFF switch. Brake pedal should lower (move down). Press and hold SUB MOTOR switch for a few seconds. Brake pedal should return. Release SUB MOTOR switch. Release brake pedal.
  4. Press and hold SUB MOTOR switch for a few seconds. Release SUB MOTOR switch. Press and hold brake pedal for approximately 15 seconds. While pressing brake pedal, press SUB MOTOR switch for a few seconds. Brake pedal should not pulsate. Release brake pedal.
  5. Repeat step 2 for FRONT LH, and REAR positions of actuator checker selector switch. After checking remaining wheels, press and hold SUB MOTOR switch for a few seconds. Remove actuator checker. Connect actuator wiring to actuator. Clear DTCs. See CLEARING DTCS  under DIAGNOSIS & TESTING .