LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> MR2 2.0 S >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Air Induction Systems >> Engine Sensors & Switches >> Turbocharging Pressure Sensor

Turbocharging Pressure Sensor

  1. Ensure ignition is off. To check turbocharging pressure sensor supply voltage, disconnect electrical connector from turbocharging pressure sensor.
  2. On MR2 Turbo, sensor is located in right (passenger's) side of engine compartment, near strut tower.
    NOTE: Turbocharging pressure sensor has a vacuum hose connected to it and may be identified by wire colors. See appropriate wiring diagram in WIRING DIAGRAMS article. Turbocharging pressure sensor may also be identified using appropriate illustration in THEORY/OPERATION article.
  3. On all models, turn ignition on. Using voltmeter, measure voltage between terminals VC and E2 of wiring harness side of electrical connector. See Fig 1. Voltage should be 4.5-5.5 volts.
  4. If voltage is not within specification, check wiring circuit. See appropriate wiring diagram in WIRING DIAGRAMS article. If voltage is correct, turn ignition off. Reinstall electrical connector on turbocharging pressure sensor.
  5. To check turbocharging pressure sensor output voltage, turn ignition on. Disconnect turbocharging pressure sensor vacuum hose from intake manifold. Connect voltmeter to terminals PIM and E2 of Engine Control Module (ECM). See Fig 2. See ECM LOCATION  table.
    ECM LOCATION

    Application Location
    MR2 Turbo Left Rear Of Engine Compartment
  6. Measure and record output voltage under ambient atmospheric pressure. Attach vacuum pump to turbocharging pressure sensor.
  7. Apply vacuum in specified increments and measure output voltage drop at each increment. See TURBOCHARGING PRESSURE SENSOR OUTPUT VOLTAGE SPECIFICATIONS  table. Replace turbocharging pressure sensor if output voltage drop is not within specification. Reinstall vacuum hose.
TURBOCHARGING PRESSURE SENSOR OUTPUT VOLTAGE SPECIFICATIONS

Applied Vacuum: In. Hg Output Voltage Drop
3.94 .15-.35
7.87 .40-.60
11.81 .65-.85
15.75 .90-1.10
19.69 1.15-1.35
Fig 1: Measuring Turbocharging Pressure Sensor Supply Voltage (MR2 Turbo Similar)
G93E79644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Measuring Turbocharging Pressure Sensor Output Voltage
G93F79645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002