LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1991 >> Pickup Base, G57 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Speed Sensor Diagnostics

Speed Sensor Diagnostics

NOTE: While diagnosing speed sensor, brake system functions as a conventional system. Ensure vehicle is not in 4WD mode.
  1. Ensure battery voltage is approximately 12 volts. Turn ignition on. Ensure REAR ANTI-LOCK light illuminates, then goes out after about 2 seconds. If REAR ANTI-LOCK light does not illuminate, check fuse, bulb and wiring harness.
  2. Turn ignition off. Using a jumper wire, connect check connector terminals Tc and E1. See Figure. Engage parking brake. Start engine. DO NOT press brake pedal. REAR ANTI-LOCK light should illuminate 4 times per second. If REAR ANTI-LOCK light does not illuminate, check parking brake switch, check connector, speed sensor installation and ABS computer connection.
  3. On 4WD models, if vehicle is in 4WD mode, diagnostic code 88 will appear. Ensure vehicle is not in 4WD mode, then re-enter SPEED SENSOR DIAGNOSTICS. On all models, if REAR ANTI-LOCK light starts flashing diagnostic code, refer to DIAGNOSTIC CODES . Repair as necessary.
    NOTE: While REAR ANTI-LOCK light is off, DO NOT accelerate, decelerate, brake, shift, move steering or drive on rough road surfaces, as these conditions will affect test.
  4. Release parking brake. Drive vehicle straight ahead at 2.5-3.7 MPH. REAR ANTI-LOCK light should go out when vehicle speed is in the specified range. If REAR ANTI-LOCK light goes out when vehicle speed is in the specified range, and blinks when vehicle speed is not in the specified range, speed sensor low speed check is completed.
  5. Drive vehicle straight ahead at 24-31 MPH. Ensure REAR ANTI-LOCK light illuminates after a one-second pause. If REAR ANTI-LOCK light illuminates without blinking when vehicle is NOT within specified speed, stop vehicle and record diagnostic codes. Turn ignition off. Repair as necessary. See SPEED SENSOR DIAGNOSTIC CODES .
  6. If REAR ANTI-LOCK light illuminates while vehicle speed is in the specified range, check is completed. If vehicle speed exceeds 34 MPH, REAR ANTI-LOCK light will blink. If REAR ANTI-LOCK light blinks when vehicle speed exceeds 34 MPH, differential ring gear is okay.
  7. Turn ignition off. Remove jumper wire from check connector. Clear diagnostic codes. See CLEARING CODES .