LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1991 >> Pickup Base, G57 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Deceleration Sensor Diagnostics

Deceleration Sensor Diagnostics

NOTE: While diagnosing deceleration sensor, brake system functions as a conventional system.
  1. Ensure battery voltage is 12 volts. Turn ignition on. REAR ANTI-LOCK light should illuminate then go out after 2 seconds. If REAR ANTI-LOCK light does not illuminate, check fuse, bulb and wiring harness.
  2. Using a jumper wire, connect check connector terminals Tc and Ts to E1. See Figure. Engage parking brake. Depress brake pedal and start engine.
    NOTE: If brake pedal is not depressed when engine is started, vehicle will enter speed sensor diagnostics.
  3. Ensure REAR ANTI-LOCK light blinks about once every second. If REAR ANTI-LOCK light does not blink, inspect parking brake switch, check connector, deceleration sensor installation and ABS computer. If REAR ANTI-LOCK light flashes diagnostic code(s), see DIAGNOSTIC CODES . Repair as necessary.
  4. Release parking brake. Drive vehicle at about 12.4 MPH or greater. Strongly depress brake pedal. REAR ANTI-LOCK light should blink about 7 times per second.
  5. If REAR ANTI-LOCK light does not respond as specified, check deceleration sensor installation. If deceleration sensor installation is okay, replace deceleration sensor. Turn engine off. Remove jumper wire from check connector terminals.