LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1991 >> Pickup Base, G57 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Component Testing >> ABS Computer Wiring Harness

ABS Computer Wiring Harness

  1. Remove ABS computer. See ABS COMPUTER  under REMOVAL & INSTALLATION. With ABS computer connector connected, backprobe ABS computer connector terminals. Measure voltage at each terminal and body ground as specified in table. See Fig 1. If circuit(s) do not test as specified, check and repair or replace trouble part shown in table.
  2. Disconnect ABS computer connectors. Check resistance and voltage on wire harness side of ABS computer connector terminals as specified in table. See Fig 2. If circuit(s) do not test as specified, check and repair or replace troubled part shown in table.
Fig 1: Testing Specs Table for ABS Computer Wiring Harness (1 of 2)
G92D01831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Testing Specs Table for ABS Computer Wiring Harness (2 of 2)
G92F01832Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002