LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Performance >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brakes -- Model X >> Brake Discs And Calipers >> Clean And Lubricate Brake Calipers Integrated Parking Brake >> Notes

Clean And Lubricate Brake Calipers Integrated Parking Brake: Notes

Last modified: 10/08/2023 16:31:48

NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
G00655219Courtesy of TESLA INC.
WARNING: Wear respiratory protective equipment in addition to standard personal protective equipment when servicing brake components.
CAUTION: Do not mix brake pads, as they have worn specifically to their respective position within the caliper. Keep the inboard pad and the outboard pad separate and organized.
CAUTION: Apply lubricants sparingly and do not permit lubricants to contact rotors, brake pad friction surfaces, or rubber brake components, especially piston seals. Use a Tesla-approved brake cleaner and clean shop towels to remove mis-applied lubricants.
NOTE: Brake calipers in this procedure may not be the same color as those installed in a particular vehicle, however the actions to perform the service are the same regardless of caliper color.

This procedure describes a service performed when all four wheels have already been removed for another service, such as a winter tire to summer tire swap. If this procedure is to be performed standalone, then add the correction code 34012501 Wheels - Vehicle - Set (Remove & Install) to the Activity.

Perform these procedures in a manner that will be the least aggressive, considering the extent of corrosion. Only when those steps are not effective, escalate the action to be more aggressive.

Fig 1: Minimal corrosion, least aggressive to be effective
G00655182Courtesy of TESLA, INC.
Fig 2: Maximum corrosion, escalate to as aggressive to be effective
G00655183Courtesy of TESLA, INC.

For example:

NOTE: On severely corroded brake calipers, the rapid vibration of an air hammer can help break up the corrosion and loosen any guide pins and brake pads stuck within the caliper. Apply the blunt tip of the air hammer to the locations where the guide pins pass through the brake pads.
Fig 3: Legacy Model S caliper shown, Palladium vehicle calipers similar
G00655184Courtesy of TESLA, INC.
NOTE: If the brake pads have worn to the point of replacement, or the condition of the pad is such that braking safety is affected, replace the pads. Clean and lubricate other brake components as originally intended.
NOTE: Replace any anti-rattle springs and bolts that are excessively corroded.