Pedal Assembly - Remove And Replace: Remove
- Open the LH front door and lower the LH front window.
- Open the hood.
- Move the driver seat fully rearwards.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Disconnect LV power. See LV Power (Disconnect and Connect) .
- Remove the LH footwell cover. See Cover - Footwell - Driver (Remove and Replace) .
- Remove the LH knee air bag. See Knee Airbag - Driver (Remove and Replace) .
- Remove the driver floor jumper air duct.
- Remove the cotter clip from the clevis pin on the pedal assembly, and remove the clevis pin from the brake pedal assembly.
- Disconnect the accelerator pedal electrical connector.CAUTION: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
- Disconnect the LH body harness electrical connector from the brake switch.
- Release the clip that attaches the LH body harness to the pedal assembly.
- Remove the brake switch from the pedal assembly.NOTE: Rotate 45 degrees clockwise to release.NOTE: Replace the brake switch if it is damaged during removal.
- Release the front carpet from the pedal assembly, and then fold it down.
- Remove and discard the nuts (x5) that attach the pedal assembly to the vehicle.
16.5 N.m (12.2 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 13 mm socket
NOTE: Discard the nuts after removal. - Remove the pedal assembly from the vehicle.NOTE: Rotate on edge to clear the link to the brake booster.