Pedal Assembly - Remove And Replace: Install
- Install the pedal assembly to the vehicle.NOTE: Rotate on edge to seat the pedal assembly around the link to the brake booster.
- Using new nyloc nuts (x5), attach the pedal assembly to the vehicle.
16.5 N.m (12.2 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 13 mm socket
NOTE: The brake booster may need to be pulled inward to seat the studs. - Fasten the clip that attaches the front carpet to the pedal assembly, and then fold the carpet down.
- Install the brake switch to the pedal assembly.NOTE: Rotate 45 degrees counter-clockwise to secure.
- Fasten the clip that attaches the LH body harness to the pedal assembly.
- Connect the LH body harness electrical connector to the brake switch.
- Connect the accelerator pedal electrical connector.CAUTION: Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
- Align brake pedal to the brake booster rod, and then install the clevis pin and clip to the brake pedal assembly.
- Install the driver floor jumper air duct.
- Install the LH knee air bag. See Knee Airbag - Driver (Remove and Replace) .
- Install the LH footwell cover. See Cover - Footwell - Driver (Remove and Replace) .
- Connect LV power. See LV Power (Disconnect and Connect) .
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Restore the driver seat back to its original position.
- Raise the LH front window and close the LH front door.