Touchscreen - HW3 - Remove And Replace: Install
WARNING: This page is about a different car, the 2024 Tesla Model S, 2023 Tesla Model S, 2022 Tesla Model S, and 2021 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
- Position the display mechanism on the touchscreen housing.NOTE: Make sure a plastic washer is installed on the top of each lower display mechanism arm.
- Install new bolts (x2) that attach the display mechanism to the touchscreen housing.NOTE: 10 mm, 10 N.m
- Position the ground strap on the touchscreen, and then install the bolt that attaches the ground strap to the touchscreen.CAUTION: Replace the bolt if it is damaged. Failure to properly reconnect the ground strap will result in display functionality issues.NOTE: 4 N.m, T20
- Position the touchscreen on the IP carrier, and then route the display harness behind the LH side of the display mechanism.
- Connect the coax and power connectors to the touchscreen, and then install the clip that attaches the harness to the display mechanism arm.NOTE: Replace the clip if it is damaged.
- Position the touchscreen shroud behind the touchscreen, and then install the tabs (x3) that attach the shroud to the touchscreen.NOTE: Slide the display downward until the tabs fully engage.
- Install the bolts (x2) that attach the touchscreen bracket to the IP carrier.NOTE: 11.5 N.mNOTE: Start the RH bolt first.
- Connect the electrical connectors (x2) for the touchscreen tilt motors, if equipped.
- Install the instrument panel service panel and phone dock. See Service Panel - Instrument Panel (Remove And Replace) .
- Connect LV power. See LV Power (Disconnect and Connect) .
- Move the RH front seat to its original position.
- Raise the RH front window.