Rear seat outer belt ASSY: Installation
NOTE:
The procedures described below are for the RH side. Perform the same procedures for the LH side.
- Installation of the rear seat 3-point type belt ASSY OUT RH
- Check of the inclination angle for activating the ELR locking operation
Courtesy of SUBARU OF AMERICA, INC.
- Slowly move the retractor from the installation position, and check that the belt is not locked when the angle is within 12° in all directions, and that it is always locked when the angle is 27° or larger in all directions.
CAUTION: Do not disassemble the retractor. - Tighten the bolt A and temporally install the retractor part of the rear seat belt ASSY OUT RH.
- Install the retractor part of the rear seat belt ASSY OUT RH with the bolt B.
Standard value: T=30N.m {306kgf.cm} {22.1ft.lbf}
Bolts A, B
- Install the floor anchor part of the rear seat belt ASSY OUT RH with the bolt.
Standard value: T=30N.m {306kgf.cm} {22.1ft.lbf}
CAUTION:- Pay attention to the direction to install the floor anchor part.
- Be careful not to allow the floor anchor part ride over the location.
- Be careful not to twist the rear seat belt ASSY OUT RH.
- ELR locking operation check
- Check that the belt is locked if quickly pulled out when it is mounted on the vehicle.
- Check of the inclination angle for activating the ELR locking operation
- Installation of the rear window side garnish RH (Refer to Power window system )
- Installation of the quarter trim lid RH (Refer to Power window system )
- Installation of the quarter lower trim RH (Refer to Installation )
- Installation of front door opening trim weather strip RH
- Installation of the front door scuff plate RH (Refer to Installation )
- Installation of the separate type rear seat cushion ASSY