LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle (Diagnostics) >> Automatic transmission system >> DTC P160A: RAM error

DTC P160A: RAM error

Circuit description

The value calculated by the transmission control computer ASSY is compared with the data recorded after the calculation when IG is ON, and when they do not match, DTC is detected and continuity to all solenoids is stopped (locked to 4th gear).

DTC No. SAE/TCCS DTC detecting condition
  1. Diagnosis condition
  2. Abnormal condition
  3. Abnormal period
  4. Other
Inspection parts
P160A
  1. IG ON
  2. Transmission control computer ASSY inside malfunction When information recorded in transmission control computer ASSY varies in the same IG ON
  3. -
  4. trips
  • Transmission control computer ASSY

Monitor description

TCM observes inner operation. If a defect is found in inner operation, TCM turns on MIL and records diagnostic codes. MONITOR STRATEGY

Applicable diagnostic codes P160A: RAM error
Required sensor/component TCM
Operation frequency Once per driving cycle
Period 1 time
MIL operation Immediate
Operation order None
TYPICAL ENABLING CONDITIONS DESCRIPTION

Ignition switch OFF to ON
TYPICAL MALFUNCTION THRESHOLDS DESCRIPTION

The value written to RAM is different from the read value. Yes

Inspection steps

  1. Replacement of transmission control computer ASSY
    1. Replace the transmission control computer ASSY. (Refer to Transmission control computer ASSY )

    Next: AT unit correction (refer to Inspection for problems that do not normally occur )