LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (HVAC System (Heater, Ventilator And A/C)) >> Compressor >> Installation

Section 41 (HVAC System (Heater, Ventilator And A/C)): Compressor: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not start the engine before charging refrigerant. 
  • If the engine is started with no refrigerant charge, replace the compressor assembly. 
  • Replace the O-rings with new parts, and then apply compressor oil to install completely. 
  • After replacing the compressor assembly, adjust the amount of the compressor oil. Ref. to  AIR CONDITIONER>COMPRESSOR OIL>ADJUSTMENT  
  1. Install the bracket V-belt cover.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  2. Install the compressor assembly.
    1. Temporarily install the compressor assembly.
    2. Tighten the bolts in the numerical order as shown in the figure.

      Tightening torque: 

      36 N.m (3.7 kgf-m, 26.6 ft-lb)

      Fig 1: Compressor Assembly Bolts Tightening Sequence
      G14612103Courtesy of SUBARU OF AMERICA, INC.
  3. Install the fuel pipe protector No. 1.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  4. Connect the compressor assembly connector and install the harness clip.
  5. Install the hose pressure suction and the hose pressure discharge.

    Tightening torque: 

    10 N.m (1 kgf-m, 7.4 ft-lb)

  6. Install the V-belts. Ref. to MECHANICAL (H4DOTC)>V-BELT>INSTALLATION
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  8. Charge refrigerant. Ref. to AIR CONDITIONER>REFRIGERANT CHARGING PROCEDURE>PROCEDURE 
  9. If replacing the compressor assembly with a new part, perform a break-in operation according to the following steps.
    CAUTION:
    • Do not increase the engine speed to and above 4, 000 r/min unless the break-in operation finishes. 
    • If the engine may have been started with no refrigerant charge, check for any diagnosis code (DTC) using Subaru Select Monitor. If the code B14A8 (REFRIGERANT NOT SEALED DRIVE ERROR) is output, replace the compressor assembly. 
    1. Check that the connector is locked securely.
    2. Reset the air conditioner control module. (Disconnect and then connect the connector)
    3. Install the delivery mode fuse. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>DELIVERY MODE
    4. Using Subaru Select Monitor, perform [Variable compressor break-in drive] in the [Maintenance support] of [Air Conditioner]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT
    5. According to the procedure, display [Break-in variable compressor drive, finish status].
    6. Start and idle the engine at or below 1, 800 r/min. (The compressor operation is automatically changed to the break-in drive mode.)
    7. When [Break-in variable compressor drive, finish status] changes from [incomplete] to [ON], stop the engine.
    8. Remove the delivery mode fuse.
    9. The break-in operation finishes.