LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Power Steering System (Service Information)) >> Universal Joint >> Inspection

Universal Joint: Inspection

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Check for wear, damage or any other faults.

  1. Check the universal joint assembly - steering for excessive looseness.

    Service limit: 

    Play of the universal joint assembly - steering: 0 mm (0 in) 

    Fig 1: Checking Universal Joint Assembly Steering For Looseness
    G08316050Courtesy of SUBARU OF AMERICA, INC.
  2. Measure the swing load of the universal joint assembly - steering.
    1. Place the universal joint assembly - steering between wooden blocks and fix it on a vise.
    2. With the yoke (a) of gearbox side facing up, measure the swing load in two directions.

      Service limit: 

      Maximum load: 

      Except for OUTBACK: 4.5 N (0.46 kgf, 1.01 lbf) or less 

      OUTBACK: 2.8 N (0.29 kgf, 0.63 lbf) or less 

      Fig 2: Measuring Universal Joint Assembly Steering Swing Load
      G08316051Courtesy of SUBARU OF AMERICA, INC.
    3. With the yoke (b) of the column assembly - steering side facing up, measure the swing load in two directions.
      Fig 3: Measuring Column Assembly Steering Swing Load In Two Directions
      G07914305Courtesy of SUBARU OF AMERICA, INC.

      Service limit: 

      Maximum load: 5.4 N (0.55 kgf, 1.21 lbf) or less 

    4. Replace as necessary, if it is found defective.