LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Transmission Control Systems) >> AT Shift Lock Solenoid and "P" Range Switch >> Inspection

AT Shift Lock Solenoid and "P" Range Switch: Inspection

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK SOLENOID UNIT. 
Measure the resistance of solenoid unit connector terminals.
Terminals 
No. 4 - No. 3: 
Is the resistance 27.6 - 30.5 Ω? Go to step 2  . Replace the solenoid unit. < Ref. to AT SHIFT LOCK SOLENOID AND "P" RANGE SWITCH . >
2 CHECK SOLENOID UNIT. 
Connect the battery to the solenoid unit connector terminals, and then operate the solenoid.
Terminals 
No. 3 (+) - No. 4 (-): 
Does the solenoid unit operate normally? Go to step 3  . Replace the solenoid unit. < Ref. to AT SHIFT LOCK SOLENOID AND "P" RANGE SWITCH . >
3 CHECK "P" RANGE SWITCH. 
  1. Shift the select lever to "P" range.
  2. Measure the resistance between "P" range switch connector terminals.

    Terminals 

    No. 1 - No. 2: 

Is the resistance less than 1 Ω? Go to step 4  . Replace the AT select lever COMPL. < Ref. to REMOVAL , Select Lever. >
4 CHECK "P" RANGE SWITCH. 
  1. Set the select lever to other than "P" range.
  2. Measure the resistance between "P" range switch connector terminals.

    Terminals 

    No. 1 - No. 2: 

Is the resistance 1 MΩ or more? Normal Replace the AT select lever COMPL. < Ref. to REMOVAL , Select Lever. >