LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Transmission - Control Systems) >> AT Shift Lock Solenoid and "P" Range Switch >> Inspection

AT Shift Lock Solenoid and "P" Range Switch: Inspection

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE CHART

Step Check Yes No
1 CHECK SHIFT LOCK SOLENOID. 
Measure the resistance of shift lock solenoid connector terminals.
Terminals 
No. 4 - No. 3: 
Is the resistance between 19.8 - 24.2 Ω? Go to step 2  . Replace the shift lock solenoid.
2 CHECK SHIFT LOCK SOLENOID. 
Connect the battery to shift lock solenoid connector terminal, and then operate the solenoid.
Terminals 
No. 3 (+) - No. 4 (-): 
Does the shift lock solenoid operate normally? Go to step 3  . Replace the shift lock solenoid.
3 CHECK "P" RANGE SWITCH. 
  1. Move the select lever to "P" range.
  2. Measure the resistance between "P" range switch connector terminals.

    Terminals 

    No. 1 - No. 2: 

Is the resistance less than 1 Ω? Go to step 4  . Replace the "P" range switch.
4 CHECK "P" RANGE SWITCH. 
  1. Set the select lever to other than "P" range.
  2. Measure the resistance between "P" range switch connector terminals.

    Terminals 

    No. 1 - No. 2: 

Is the resistance 1 MΩ or more? Normal Replace the "P" range switch.