LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Impreza Sport Limited >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Transmission Control Systems (Except WRX-STI) >> MT Gear Shift Lever >> Installation

MT Gear Shift Lever: Installation

  1. Install the joint to the transmission and secure with a spring pin.
    Fig 1: Identifying Gear Shift Lever Joint And Spring Pin
    G08317597Courtesy of SUBARU OF AMERICA, INC.
  2. Insert the gear shift lever from the room side.
    NOTE: Insert the rod and the stay, and then temporarily set them onto the transmission mount.
    Fig 2: Inserting Gear Shift Lever From Room Side
    G08317598Courtesy of SUBARU OF AMERICA, INC.
  3. Lift up the vehicle.
  4. Mount the cushion rubber on the vehicle body.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 3: Identifying Gear Shift Lever Stay And Cushion Rubber
    G08317599Courtesy of SUBARU OF AMERICA, INC.
  5. Connect the rod to the joint.
    NOTE: Use a new self-locking nut.

    Tightening torque: 

    12 N.m (1.2 kgf-m, 8.9 ft-lb) 

    Fig 4: Locating Joint Rod Bolt
    G08317600Courtesy of SUBARU OF AMERICA, INC.
  6. Connect the stay to the shift bracket.
    NOTE: Use a new self-locking nut.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 5: Identifying Gear Shift Lever Stay And Shift Bracket
    G08317601Courtesy of SUBARU OF AMERICA, INC.
  7. Install the center exhaust cover.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 6: Identifying Center Exhaust Cover
    G08317548Courtesy of SUBARU OF AMERICA, INC.
  8. Install the rear exhaust pipe. Refer to INSTALLATION , Rear Exhaust Pipe.
  9. Lower the vehicle.
  10. Install the plate COMPL to the body.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    1. Set the plate COMPL to the vehicle.
    2. Temporarily tighten the bolt (A).
    3. Tighten the bolt (B).
    4. Tighten the bolt (A).
    5. Tighten the bolts (C) and (D).
    6. Tighten the console side cover attachment screws.
      Fig 7: Identifying Console Side Cover Mounting Bolts
      G08317603Courtesy of SUBARU OF AMERICA, INC.
  11. Install the harness clamp to the plate.
  12. Install the boot and insulator assembly, and secure with a clamp.
    Fig 8: Identifying Boot And Insulator Assembly
    G08317587Courtesy of SUBARU OF AMERICA, INC.
  13. Install the cover - shift lever, and install the gear shift knob.
  14. Make sure the gears can be shifted accurately into each gear.