LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Impreza Sport Limited >> Repair and Diagnosis >> Maintenance >> Procedures >> General Information (Except WRX-STI) >> Note >> Note >> Tie-Downs

General Information (Except WRX-STI): Note: Note: Tie-Downs

Tie-downs are used when transporting vehicles and when using the chassis dynamo. Attach tie-down only to the specified locations on the vehicle.

CAUTION:
  • Pull the front and rear of the vehicle in the opposite direction, and pull the left and right of the vehicle in the same direction.
  • Patterns except for the followings (recommended) are not allowed.
Fig 2: Identifying Tie-Down Direction
G05659215Courtesy of SUBARU OF AMERICA, INC.
CAUTION: When the vehicle is tied down from vehicle inside, hook the hooks of tie-down chain on the rear tie-down hooks from vehicle inside. When the vehicle is tied down from vehicle outside, hook the hooks of tie-down chain on the rear tie-down hooks from vehicle outside.
Fig 3: Identifying Front Tie-Down Hook, Rear Tie-Down Hole And Chain Pulling Range At Tie-Down Condition
G08315215Courtesy of SUBARU OF AMERICA, INC.

For sea transportation

CAUTION: The eye bolts are exclusively used for towing and sea transportation tie-down, and do not use them for ground and freight transportation.
Fig 4: Identifying Front Tie-Down Hook, Chain Pulling Range At Tie-Down Condition And Eye Bolt
G08315216Courtesy of SUBARU OF AMERICA, INC.
CAUTION: The vehicle sinking volume at tie-down condition should be less than 50 mm (1.97 in) and make sure to fix the vehicle securely.
Check to see if the tensions of chains or belts at tie-down condition are appropriate in the following procedures.
  1. Before tie-down, measure the distance between the highest tire point and highest arch point at the center of wheel.
  2. After tie-down, measure the distance between the highest tire point and highest arch point at the center of wheel.
  3. If the distance (A) between the measured value of 1) and 2) above, is less than 50 mm (1.97 in), it is judged as OK. If the distance is 50 mm (1.97 in) or more, it is judged as NG because the tension is too high.
    Fig 5: Identifying Arch Position Before Tie-Down And Arch Position After Tie-Down
    G08315217Courtesy of SUBARU OF AMERICA, INC.

When the vehicle is tied down from vehicle inside, hook the hooks of tie-down chain from vehicle inside, and when the vehicle is tied down from vehicle outside, hook the hooks of tie-down chain from vehicle outside. For front tie-down hook, use S hook and J hook, and for rear tie-down hole, use S hook, J hook and T hook. T hook can be used only for rear tie-down hole.