LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Impreza Sport Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (H4DO) (Except WRX-STI) >> Throttle Body >> Removal

Throttle Body: Removal

  1. Disconnect the ground cable from battery.
    Fig 1: Connecting/Disconnecting Battery Ground Cable
    G08317298Courtesy of SUBARU OF AMERICA, INC.
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to REMOVAL , Front Under Cover.
  4. Drain approximately 3.0 2 (3.2 US qt, 2.6 Imp qt) of coolant. Refer to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
  5. Remove the clip (A) from the air intake boot.
  6. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
  7. Loosen the clamp (C) which connects the air intake boot and throttle body.
    Fig 2: Identifying Air Intake Boot Clip And Clamps
    G08317299Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the air intake boot from the throttle body, and move the air intake boot to the left side wheel apron.
    Fig 3: Identifying Air Intake Boot
    G08317300Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connectors (A) from the throttle position sensor.
  10. Disconnect the preheater hose (B) from the throttle body.
    Fig 4: Identifying Throttle Position Sensor Connector And Preheater Hose
    G08315327Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the throttle body from the intake manifold.
    Fig 5: Locating Throttle Body Mounting Bolts
    G08315328Courtesy of SUBARU OF AMERICA, INC.