LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Forester X Premium, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Fuel Injection System (H4SO)) >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different car, the 2009 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knock sensor to the cylinder block.
    NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

    Tightening torque: 

    24 N.m (2.4 kgf-m, 17.7 ft-lb) 

    Fig 1: Identifying Knock Sensor Cord Area
    G05953741Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the knock sensor connector.
    Fig 2: Identifying Knock Sensor Connector
    G05659388Courtesy of SUBARU OF AMERICA, INC.
  3. Install the air intake chamber.

    Refer to INSTALLATION , Air Intake Chamber .

  4. Connect the battery ground cable to battery.
Fig 3: Connecting Battery Ground Cable To Battery
G05016809Courtesy of SUBARU OF AMERICA, INC.