LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> Impreza Outback Sport, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch System) >> Operating Cylinder >> Installation

Operating Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install in the reverse order of removal.
    NOTE:
    • Before installing the operating cylinder, apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.
    • For turbo model, bleed air with the operating cylinder installed to the clutch hose and install the operating cylinder to the body. <Ref. to STI MODEL , PROCEDURE, Clutch Fluid Air Bleeding .>
    • Non-turbo model

    Tightening torque: 

    T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb) 

    Fig 1: Identifying Operating Cylinder - Non-Turbo Model
    G05003667
    • Turbo model

    Tightening torque: 

    T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    T2:37 N.m (3.8 kgf-m, 27.5 ft-lb) 

    Fig 2: Identifying Operating Cylinder - Turbo Model
    G05003668
    • STI model

    Tightening torque: 

    T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    T2:41 N.m (4.2 kgf-m, 30.2 ft-lb) 

    Fig 3: Identifying Operating Cylinder - STI Model
    G05003669
    NOTE:
    • Be sure to install the clutch hose with the mark side facing upward.
    • Be careful not to twist the clutch hose during installation.
    • Fig 4: Identifying Operating Cylinder, Clutch Hose And Mark
      G05336425
  2. After bleeding air from the operating cylinder, ensure that the clutch operates properly. <Ref. to CLUTCH FLUID AIR BLEEDING .>