LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester F4-2.5L SOHC >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Adjustments >> Select Cable

Select Cable

Select Cable

ADJUSTMENT
1. Set the vehicle on a lift.
2. Set the select lever to "N" range.
3. Lift-up the vehicle.
4. Remove the rear exhaust pipe and muffler.
5. Remove the heat shield cover. (If equipped)
6. Loosen the adjusting nuts on both sides.





7. Turn the adjusting nut B until it lightly touches the connector.





8. Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 Nm (0.76 kgf-m, 5.5 ft. lbs.)





9. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
10. Install in the reverse order of removal.