LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (5AT) >> Automatic Transmission >> Oil Pump Cover >> Assembly >> Front Brake

Front Brake

  1. Apply ATF to D-ring, and then install it to the front brake piston.
  2. Install the front brake piston to oil pump cover.
    NOTE: Install by aligning the " Triangle " mark on front brake piston surface with the oil pump cover rib.
    Fig 1: Installing Front Brake Piston To Oil Pump Cover
    G03831791Courtesy of SUBARU OF AMERICA, INC.
  3. Install the retainer and return spring.
  4. Install the front brake piston assembly using ST1, ST2 and ST3.

    ST1 18762AA000 COMPRESSOR SPECIAL TOOL

    ST2 18765AA000 COMPRESSOR SUPPORT

    ST3 18763AA000 COMPRESSOR SHAFT

    Fig 2: Installing Front Brake Piston Assy Using Special Tools
    G03831792Courtesy of SUBARU OF AMERICA, INC.
  5. Install the genuine driven plate instead of retainer plate, temporarily assemble the drive plate and driven plate.

    Part No. 31536AA290 DRIVEN PLATE

  6. Install the snap ring.
    Fig 3: Installing Snap Ring
    G03831793Courtesy of SUBARU OF AMERICA, INC.
  7. Measure the clearance between retainer plate and snap ring, and then select a suitable retainer plate from table.

    Front brake clearance standard value: 

    0.7-1.1 mm (0.028-0.043 in) 

    Fig 4: Measuring Clearance Between Retainer Plate And Snap Ring
    G03831794Courtesy of SUBARU OF AMERICA, INC.
    FRONT BRAKE RETAINER PLATE THICKNESS SPECIFICATION

    Front brake retainer plate
    Part Number Thickness mm (in)
    31567AB130 3.4 (0.134)
    31567AB140 3.6 (0.142)
    31567AB150 3.8 (0.150)
    31567AB160 4.0 (0.157)
  8. Remove the snap ring, replace the drive plate which used in measurement of clearance with retainer plate, and then reassemble.