LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (5AT) >> Automatic Transmission >> Converter Case >> Removal

Converter Case: Removal

  1. Remove the transmission assembly from vehicle. < Ref. to , REMOVAL , Automatic Transmission Assembly. >
  2. Remove the torque converter assembly. < Ref. to , REMOVAL , Torque Converter Assembly. >
  3. Remove the transmission harness connector from stay.
  4. Remove the turbine speed sensor 1. < Ref. to , REMOVAL , Turbine Speed Sensor 1. >
  5. Remove the oil charge pipe. < Ref. to , REMOVAL , Oil Charge Pipe. >
  6. Remove the ATF filter inlet and outlet pipes. < Ref. to , REMOVAL , ATF Filter. >
  7. Remove the converter case aligning bolt.
  8. Lay along the transmission body, and then remove the oil pan.
  9. Remove the three converter case aligning bolts (TORX®).

    ST 18676AA020 TORX® WRENCH

    Fig 1: Removing Converter Case Aligning Bolts
    G03831780Courtesy of SUBARU OF AMERICA, INC.
  10. Separate the converter case by lightly tapping with plastic hammer.
  11. Remove the differential assembly. < Ref. to , REMOVAL , Front Differential Assembly. >
  12. Remove the oil seal from converter case.