LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Impreza WRX STi >> Repair and Diagnosis >> Maintenance >> Procedures >> General Information >> Periodic Maintenance Service >> ATF >> Replacement >> Automatic Transmission Fluid

Automatic Transmission Fluid

  1. Drain the ATF (Automatic Transmission Fluid) by removing drain plug using TORX(R) BIT T70.
    NOTE: Before starting work, cool off the ATF well.
    Fig 1: Identifying Automatic Transmission Fluid Drain Plug
    G03812488Courtesy of SUBARU OF AMERICA, INC.
  2. Replace the gasket with a new one, and then tighten the specified torque.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.1 ft-lb) 

  3. Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.

    Recommended fluid: 

    Dexron III type automatic transmission fluid 

    Fluid capacity: 

    Fill the same amount drained from A TF drain plug hole. 

  4. Check the ATF level. < Ref. to INSPECTION , ATF. >
    Fig 2: Checking ATF Level
    G03812489Courtesy of SUBARU OF AMERICA, INC.