LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Impreza WRX STi >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection (Fuel Systems) -- H4DOTC >> Front Oxygen (A/F) Sensor >> Installation

Front Oxygen (A/F) Sensor: Installation

  1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portion of front oxygen (A/F) sensor to make the next removal easier.

    Anti-seize compound: 

    SS-30 by JET LUBE 

    CAUTION: Never apply anti-seize compound to protector of front oxygen (A/F) sensor.
  2. Install the front oxygen (A/F) sensor.

    Tightening torque: 

    30 N.m (3.1 kgf-m, 22.1 ft-lb) 

    Fig 1: Installing Front Oxygen (A/F) Sensor
    G03816878Courtesy of SUBARU OF AMERICA, INC.
  3. Install the service hole cover.
    Fig 2: Installing Service Hole Cover
    G03816879Courtesy of SUBARU OF AMERICA, INC.
  4. Lower the vehicle.
  5. Install the front right side wheel.
  6. Connect the engine harness to the bracket (B) using clips (A).
    Fig 3: Connecting Engine Harness To Bracket Using Clips
    G03816880Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the connector of front oxygen (A/F) sensor.
    Fig 4: Connecting Connector Of Front Oxygen (A/F) Sensor
    G03816881Courtesy of SUBARU OF AMERICA, INC.
  8. Connect the battery ground cable to battery.
    Fig 5: Connecting Battery Ground Cable To Battery
    G03816882Courtesy of SUBARU OF AMERICA, INC.