LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Impreza WRX STi >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> FUEL INJECTION (FUEL SYSTEMS) -- STi >> Fuel Sub Level Sensor >> Removal

Fuel Sub Level Sensor: Removal

WARNING:
  • Place "NO FIRE" signs near the working area.
  • Be careful not to spill fuel on the floor.
  • Reduce the fuel on the fuel tank to less than 3/4 beforehand. Be careful that fuel may spill when the fuel is more than 3/4.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G03818018Courtesy of SUBARU OF AMERICA, INC.
  2. Lift-up the vehicle.
  3. Set a container under the vehicle and remove the drain plug from fuel tank to drain fuel.
    Fig 2: Removing Drain Plug From Fuel Tank To Drain Fuel
    G03818019Courtesy of SUBARU OF AMERICA, INC.
  4. Tighten the fuel drain plug.
    NOTE: Use a new gasket.

    Tightening torque: 

    26 N.m (2.65 kgf-m, 19.2 ft-lb) 

    Fig 3: Tightening Fuel Drain Plug
    G03818020Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the rear seat.
  6. Remove the service hole cover.
    Fig 4: Removing Service Hole Cover
    G03818021Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from the fuel sub level sensor.
  8. Disconnect the fuel jet pump hose.
    Fig 5: Disconnecting Fuel Jet Pump Hose
    G03818022Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the bolts which install the fuel sub level sensor on fuel tank.
    Fig 6: Removing Bolts Of Fuel Sub Level Sensor On Fuel Tank
    G03818023Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the fuel sub level sensor.
    Fig 7: Removing Fuel Sub Level Sensor
    G03818024Courtesy of SUBARU OF AMERICA, INC.