LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power Assisted Steering >> Oil Pump >> Installation >> Turbo Model

Turbo Model

  1. Install the oil pump to the bracket.
    1. Place the oil pump bracket in a vise. Tighten the bushing using a 12.7 mm (1/2") type 14 and 21-mm box wrench until it is in contact with oil pump mounting surface.
      CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.
      Fig 1: Placing Oil Pump Bracket In Vise
      G01980979Courtesy of SUBARU OF AMERICA, INC.
    2. Tighten the bolt which installs oil pump to the bracket.
      1. Tightening torque:  37.3 N.m (3.8 kgf-m, 27.5 ft-lb)
      Fig 2: Tightening Bolt Which Installs Oil Pump To Rear Of Bracket
      G01980980Courtesy of SUBARU OF AMERICA, INC.
      1. Tightening torque:  15.7 N.m (1.6 kgf-m, 11.6 ft-lb)
      Fig 3: Tightening Bolts Which Installs Oil Pump To Front Of Bracket
      G01980981Courtesy of SUBARU OF AMERICA, INC.
  2. Tighten the bolts which install power steering pump bracket.
    1. Tightening torque:  22 N.m (2.2 kgf-m, 15.9 ft-lb)
    Fig 4: Tightening Bolts Which Install Power Steering Pump Bracket
    G01980982Courtesy of SUBARU OF AMERICA, INC.
  3. Interconnect the pipes C and suction hose.

    Tightening torque: 

    1. Joint nut;  39.2 N.m (4 kgf-m, 28.9 ft-lb)
    CAUTION: If a hose is twisted at this step, the hose may come into contact with some other parts.
    Fig 5: Interconnecting Pipes C & Suction Hose
    G01980983Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the connector to the power steering oil pressure switch.
  5. Install the pulley belt to the oil pump.
  6. Check the pulley belt tension. See DRIVE BELT ADJUSTMENT , V-belt.
  7. Tighten the bolt belt tension.
    1. Tightening torque:  8 N.m (0.8 kgf-m, 5.8 ft-lb)
  8. Install the pulley belt cover.
  9. Connect the ground terminal of battery.
  10. Feed the specified power steering fluid. See POWER STEERING FLUID  .
    CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might seize up.