LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Overhaul) >> Control Valve Body >> Installation

Control Valve Body: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set the range select lever in "N" range.
  2. Install the control valve, ATF temperature sensor and ground connectors.
    1. Tightening torque:  8 N.m (0.8 kgf-m, 5.8 ft-lb)
    Fig 1: Installing Control Valve Bolts
    G01998845Courtesy of SUBARU OF AMERICA, INC.
  3. Connect all connectors.
    Fig 2: Connect All Connectors
    G01998846Courtesy of SUBARU OF AMERICA, INC.
  4. Attach the magnet at specified position.
    Fig 3: Attaching Magnet At Specified Position
    G01998847Courtesy of SUBARU OF AMERICA, INC.
  5. Apply proper amount of liquid gasket to the entire oil pan mating surface.
    1. Liquid gasket:  Three Bond 1217B (Part No.K0877YA020)
    Fig 4: Applying Liquid Gasket To Oil Pan Mating Surface
    G01998848Courtesy of SUBARU OF AMERICA, INC.
  6. Apply a plenty amount of liquid gasket to three holes other than screw holes on transmission case.
    1. Liquid gasket:  Three Bond 1217B (Part No.K0877YA020)
    Fig 5: Applying Liquid Gasket To Three Holes
    G01998849Courtesy of SUBARU OF AMERICA, INC.
  7. Install the oil pan.
    1. Tightening torque:  5 N.m (0.5 kgf-m, 3.6 ft-lb)
  8. Pour ATF into the oil charge pipe. See ATF .
  9. Check the level of ATF.

    See ATF .