LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft Systems >> Symptom Diagnosing & Testing >> Anti-Theft/Security System Symptom Tests >> Check Security Horn

Check Security Horn

  1. Remove and inspect security horn relay. See SECURITY HORN RELAY  under COMPONENT TESTS. Replace relay as necessary. If security horn relay is okay, go to next step.
  2. Turn ignition on. Measure voltage between security horn relay harness connector terminal No. 1 and ground. See Figure . If voltage is more than 10 volts, go to next step. If voltage is less than 10 volts, check harness for open circuits and shorts between security horn relay and horn relay.
  3. Measure voltage between security horn relay connector terminal No. 2 and ground. If voltage is more than 10 volts, go to next step. If voltage is less than 10 volts, check harness for open circuits and shorts between security horn relay and fuse.
  4. Turn ignition off. Disconnect security horn relay harness connector. Measure resistance between security horn relay connector terminal No 3 and security control module connector terminal No. 18. See Figure and Figure . If resistance is less than 10 ohms, go to next step. If resistance is more than 10 ohms, check harness for open circuits and shorts between security horn relay and security control module.
  5. Measure resistance between security horn relay connector terminal No. 4 and security control module connector terminal No. 16. If resistance is less than 10 ohms, go to next step. If resistance is more than 10 ohms, check harness for open circuits and shorts between security horn relay and security control module.
  6. Disconnect security horn harness connector. Measure resistance between security control module connector terminal No. 17 and security horn connector terminal No. 1. If resistance is less than 10 ohms, go to next step. If resistance is more than 10 ohms, check harness for open circuits and shorts between security control module and security horn.
  7. Remove and inspect security horn. See SECURITY HORN  under REMOVAL & INSTALLATION. Replace security horn as necessary. If security horn is operating properly, replace security control module. See SECURITY CONTROL MODULE  under REMOVAL & INSTALLATION.