Check Clearance Light Operation
- Turn parking switch on. If clearance light illuminates, go to next step. If clearance light does not illuminate, check clearance light circuit.
- Turn parking switch off. Disconnect security control module harness connector. Measure voltage between security control module harness connector terminal No. 11 and ground. If voltage is more than 10 volts, go to next step. If voltage is less than 10 volts, check harness for open circuits and shorts between security control module and fuse.
- Disconnect fuse box harness connector. Measure resistance between security control module harness connector terminal No. 12 and fuse box harness connector terminal No. 11. If resistance is less than 10 ohms, replace security control module. See SECURITY CONTROL MODULE under REMOVAL & INSTALLATION. If resistance is more than 10 ohms, check harness for open circuits and shorts between security control module and fuse.