Clutch Release Bearing And Lever: Installation
CAUTION:
Before or during assembling, lubricate the following points with a light coat of grease.
- Contact surface of lever and pivot
- Contact surface of lever and bearing
- Transmission main shaft spline (Use grease containing molybdenum disulfide.)
- While pushing clutch release lever to pivot and twisting it to both sides, fit retainer spring onto the constricted portion of pivot.NOTE:
- Apply grease (SUNLIGHT 2: P/N 003602010) to contact point of clutch release lever and operating cylinder.
- Confirm that retainer spring is securely fitted by observing it through the main case hole.
- Install clutch release bearing and fasten it with two clips.
- Install clutch release lever sealing.
- Install operating cylinder.
Tightening torque: 37+/-3 N.m (3.8+/-0.3 kg-m, 27.5+/-2.2 ft-lb)
- After remounting engine and transmission on body. See MT MODEL .
- Bleed air from oil line with the help of a coworker. See ON-CAR SERVICE .