Error Message Displayed During Initial Startup Of WSS Weight Sensing System (LI91.10-P-065179)
WARNING: This page is about the Fortwo Electric Drive, 2D Convertible, which is a different variant/trim than selected.
Publication date: 2016-11-07Reference number: LI91.10-P-065179
ERROR MESSAGE DISPLAYED DURING INITIAL STARTUP OF WSS WEIGHT SENSING SYSTEM
TECHNICAL SERVICE BULLETIN
Reference Number(s): LI91.10-P-065179 Version 1, Date of Issue:
November 07, 2016
| SMART: | Weight sensing system WSS |
| DESIGN GROUP: | 91.10 Front seats |
COMPLAINT
Error message may be displayed during initial startup of the weight sensing system (WSS)
The following fault messages may be stored in the WSS control unit event log:
- B00A054 - The control unit "Weight sensing system" has a malfunction. Calibration was not performed.
- U100856 - LIN bus 1 has a malfunction. An incorrect or incompatible configuration was detected.
The following status message may appear in the weight sensing system control unit (N110) event log:
- Status of configuration "NOT OK" (Pic. 1)
CAUSE
It is possible that an incorrect or incompatible WSS service kit could have been installed.
ATTACHMENTS
ATTACHMENTS
| File | Description |
|---|---|
| Pic 1.jpg | Status of configuration NOT OK |
REMEDY
Please create a PTSS Case with an attached WSS control unit event log so that this can be forward to Engineering
After installation of the new WSS service kit, the following message should appear in the WSS control unit event log:
- Status of configuration "OK" (Pic. 2)
- The fault messages B00A054/U100856 should no longer be active
IMPORTANT:
The SRS control unit N2/10 must not be replaced in these cases!
ATTACHMENTS
ATTACHMENTS
| File | Description |
|---|---|
| Pic 2.jpg | Status of configuration OK |
CONTROL UNIT/FAULT CODE
CONTROL UNIT/FAULT CODE
| Control unit | Fault code | Fault text |
|---|---|---|
| N2/10 - Supplemental restraint system (SRS) (ORC453) | B00A054 | The control unit 'Weight sensing system' has a malfunction. Calibration is missing. (OCM453) |
| N2/10 - Supplemental restraint system (SRS) (ORC453) | U100856 | LIN bus 1 has a malfunction. An incorrect or incompatible configuration was detected. |
OPERATION NUMBERS/DAMAGE CODES
OPERATION NUMBERS/DAMAGE CODES
| Op. no. | Operation text | Time | Damage code | Note |
|---|---|---|---|---|
| 82148 90 | Weight sensing system seat occupancy recognition control unit software release |
WIS-REFERENCES
WIS-REFERENCES
| Document number | Title | Note | Allocation |
|---|---|---|---|
| AR91.10-P-3310SR | Remove/install seat cushion | SI91.10-P-0012A | Remedy |