Tire Pressure Sensor: Removal
- When replacing a wheel or tire, tire pressure sensors must be set up in one of the following ways:
- Remove the sensor from the old wheel and install it in the new wheel.
- Keep the same wheel with tire pressure sensor, and replace only the tire.
- Use a new wheel and sensor (the new sensor must be registered after installation).
- Remove wheel. Remove the cap and valve core, and release air from the tire. See Fig 1.
- After ensuring that air is sufficiently released, remove the nut and washer that is used to hold the tire pressure sensor and drop the sensor inside the tire.NOTE: Keep the removed cap, valve core, nut and washer.
- After dropping the tire pressure sensor into the tire, disengage the bead using the shoe of the tire remover. See Fig 2.NOTE: Be careful not to damage the tire pressure sensor due to interference between the sensor and tire bead.
- Remove the bead on the upper side following the usual procedure.
- Take out the sensor from the tire, and remove the bead on the lower side following the usual procedure.
- Remove the inner grommet from the tire pressure sensor, or retrieve from the wheel, if necessary.NOTE: Check that no cracks or damage are visible on the grommet. If so, replace the grommet together with the washer and nut. Always replace grommet and washer when replacing the warning valve and transmitter.
NOTE:
Tire pressure sensor is powered by a lithium battery. When sensor is defective, remove battery from sensor and dispose of properly.