LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2012 >> xD Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes (P0420-P1605)) >> SFI System >> DTC P0500: Vehicle Speed Sensor "A" >> Typical Enabling Conditions

Typical Enabling Conditions

MANUAL TRANSAXLE:

Monitor runs whenever following DTCs not present None
Time after ignition switch turned from off to ON 3 seconds or more
Battery voltage 8 V or higher
Ignition switch ON
Starter OFF
Fuel-cut ON
AUTOMATIC TRANSAXLE:

Monitor runs whenever following DTCs not present None
Ignition Switch ON
Time after Ignition switch OFF to ON 3 seconds or more
Battery voltage 8 V or higher
Starter OFF
Either of following conditions (a) or (b) met: -
(a) Following conditions 1 and 2 met: -
1. ECT and ECT sensor 20°C (68°F) or more, and sensor does not malfunction (P0115 or P0117, P0118, P0125)
2. Time after PNP switch turned OFF 10 seconds or more
(b) Following conditions 1 and 2 met: -
1. ECT and ECT sensor Less than 20°C (68°F), and sensor malfunction (P0115 or P0117, P0118, P0125)
2. Time after PNP switch turned OFF 30 seconds or more
TP sensor fail (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) Not detected
Engine speed 2210 rpm or more (varies with throttle valve opening angle)
Fuel cut at high engine speed Not executing
Time after ignition switch turned to ON More than 0.5 seconds
TP sensor learning Completed