Installation Procedure
- During removal and installation, make sure that the markings (arrows) are in the positions illustrated.
- The airbag contact unit must not be twisted.
- Insert the steering wheel in the column integration module (CIM). The guide pin (1) on the back of the steering wheel must engage in the carrier (2) of the CIM.
- Guide the airbag (1) wiring harness through the opening in the steering wheel hub.
- Ensure that the marks (2) on the steering wheel and steering shaft align.
- Clean the thread and install a new bolt with locking compound.
- Install the steering wheel to the steering shaft.
Position the steering wheel on the steering column.
Tighten: Tighten the bolt to 30 N.m (22 lb ft).
- Connect the wiring harness plug for the horn/infotainment.
- Install the steering wheel airbag module. Refer to Steering Wheel Inflatable Restraint Module Replacement .
- Connect the negative cable battery.
NOTE:
CAUTION:
Refer to Fastener Caution
.
NOTE: