Circuit/System Testing
- Ignition OFF, Disconnect the harness connectors at the PSCM.
- Ignition OFF, verify that there is less than 3.0 ohms between the ground circuit terminal 2 X2 and ground.
- If greater than the specified value, test the ground circuit for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the battery positive voltage circuit terminal 1 X2 and ground.
- If test lamp did not illuminate, test the battery positive voltage circuit for a short to ground or an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the ignition voltage circuit terminal 1 X1 and ground.
- If test lamp did not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the PSCM.