Circuit/System Testing
- Operate the vehicle in 3rd gear. Observe Gear Ratio parameter on the scan tool. The Gear Ratio parameter should not equal 2.84:1.
- If the Gear Ratio parameter equals 2.84:1 while in 3rd gear, test or replace the:
- Shift solenoid 2 valve assembly
- U1 shift valve
Refer to Control Valve Body Assembly Disassemble procedure.
- If all conditions test normal, test or replace the control valve body assembly. Refer to Control Valve Body Assembly Installation , Control Valve Body Assembly Removal procedures.
- If the Gear Ratio parameter equals 2.84:1 while in 3rd gear, test or replace the:
- Perform a line pressure test. Refer to Line Pressure Check procedure.
- Remove the Control valve body cover. Refer to Control Valve Body Cover Removal procedure.
- Inspect the inside of the control valve body cover for excessive sediment. There should not be excessive sediment.
- If excessive sediment is found inspect and replace as necessary the Torque converter assembly, Input shaft, and Fluid pump stator shaft assembly. Refer to Torque Converter Assembly Removal , Forward and Direct Clutch Assembly, and Transmission Fluid Pump Cleaning and Inspection procedures.
- If all conditions test normal, test or replace the transmission.
- Inspect the control valve body assembly for the following conditions. The conditions should not be found.
- Stuck lock up relay valve
- Stuck lock up control valve
- Stuck TCC check valve
- Stuck secondary regulator valve
- Stuck solenoid relay valve
- Stuck TCC lock up PC solenoid valve assembly
Refer to Control Valve Rear Body Disassemble and Control Valve Body Disassemble - Middle .
- If any of the above conditions are found, replace the valve body assembly. Refer to Control Valve Body Assembly Installation , Control Valve Body Assembly Removal procedures.
- Verify that the control valve body has been serviced within the past 3 months.
- If the control valve body has not been serviced, replace the control valve body assembly. Refer to Control Valve Body Assembly Installation , Control Valve Body Assembly Removal procedures.
- If all circuits and components test normal, replace the transmission.