LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> SW2 Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission Clutches >> Manual Transaxle Removal And Installation >> Transaxle Disassembly/Assembly >> Input Shaft Clearance Measurement

Input Shaft Clearance Measurement

  1. Assemble input shaft with 5th gear bearing, 5th gear, 5th reverse synchronizer assembly, reverse cone, and washer. Use old nut and torque.

    Torque Input Shaft Clamp Nut: 150 N.m (111 ft-lbs) 

  2. Measure clearance between 5th drive gear and 5th gear thrust washer.

    Clearance between 5th drive gear and 5th gear thrust washer 

    Standard: 0.20-0.35 mm (0.008-0.014 in.) 

    Fig 1: Clearance Between 5th Drive Gear And 5th Gear Thrust Washer
    G01033470Courtesy of GENERAL MOTORS CORP.
  3. Measure clearance between 4th drive gear and 4th gear thrust washer.

    Clearance between 4th drive gear and 4th gear thrust washer 

    Standard: 0.20-0.35 mm (0.008-0.014 in.) 

  4. Measure clearance between 3rd drive gear and input shaft.

    Clearance between 3rd drive gear and input shaft Standard: 0.20-0.35 mm (0.008-0.014 in.) 

    Fig 2: Clearance Between 4th Drive Gear, 4th Gear Thrust Washer and 3rd Drive Gear
    G01033471Courtesy of GENERAL MOTORS CORP.