LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> SW2 Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission Clutches >> Manual Transaxle Removal And Installation >> Shift/Selector Cable (On-Vehicle) >> Installation

Shift/Selector Cable (On-Vehicle): Installation

NOTE: All service replacement shift cables will have the bolt in type pass through grommet.
NOTE: The bolt in type cable pass-through grommet is installed from the inside of the vehicle.
  1. For service replacement shift cables, perform the following steps:
    1. Separate and fold back sound deadener from front of dash.
    2. Place cables and retaining plate through front of dash and push grommet into opening being sure to properly align grommet pilot into front of dash.
      Fig 1: Installing Cable And Grommet
      G01033350Courtesy of GENERAL MOTORS CORP.
      NOTE: When removing and installing shift cables it is helpful to have a second person inside vehicle to guide cables and prevent them from being tangled.
    3. Raise vehicle.
      NOTE: Make sure insulation material does not become trapped between grommet and front of dash.
    4. Place retaining plate on studs and install nuts.

      Torque Shift Cable Pass-Through Grommet Nuts: 6 N.m (53 in-lbs) 

    NOTE: When removing and installing shift cables it is helpful to have a second person inside vehicle to guide cables and prevent them from being tangled.
  2. For production shift cables, perform the following steps:
    1. Raise vehicle.
      NOTE: The snap in type cable pass-through grommet is installed from outside of vehicle.
    2. Guide cables through cable pass-through hole in floor pan.
    3. Insert cable pass-through grommet into cable pass-through hole in floor pan, engaging passenger side of grommet first. Snap driver's side of grommet into place by pressing inward and toward passenger side of vehicle.
  3. Lower vehicle.
    NOTE: Do not drag boot through bracket hole as boot damage may occur.
  4. Insert cables into clutch housing and install retainers. Use care not to kink cables and be sure cables are not crossed.
    NOTE: The notched edge on the shift cable must face up.
  5. Connect the cables to the shift arms on the shift control housing and install retainers.
    Fig 2: Connecting Shift Cables
    G01033351Courtesy of GENERAL MOTORS CORP.
  6. Install air cleaner housing and duct assembly. Refer to AIR CLEANER HOUSING AND DUCT ASSEMBLY  .
    Fig 3: Air Cleaner Housing And Duct Assembly
    G01033352Courtesy of GENERAL MOTORS CORP.
  7. Install shifter control assembly. Refer to SHIFTER CONTROL ASSEMBLY (ON-VEHICLE)  .
  8. Replace sound deadening material and resecure to front of dash.
  9. Replace carpeting.
  10. Enable SIR system.