LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> SC2 Standard, MP3 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Removal & Installation >> Control Arm & Ball Joint >> Installation

Control Arm & Ball Joint: Installation

  1. Install control arm onto tension strut, DO NOT install nut and washer. See Figure . Position end of control arm into cradle. Install bolt and nut. Tighten to specification. See TORQUE SPECIFICATIONS  .
  2. Install nut and washer securing tension strut onto control arm. Tighten to specification. See TORQUE SPECIFICATIONS  . Thoroughly clean and lubricate ball joint stud threads. DO NOT lubricate unthreaded portion of stud.
  3. Install control arm onto steering knuckle. Install castle nut. Tighten to specification. See TORQUE SPECIFICATIONS  . Install NEW cotter pin (if necessary, tighten castle nut further, but only as far as is necessary to install cotter pin).
  4. Install inner fender splash shield. Remove rust and corrosion from mounting surfaces of wheel and brake rotor. Install wheel. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  . Check front wheel alignment. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.