Diagnostic Procedures
- Start engine and ensure cruise control is off. Using scan tool, check for DTC P0565. If DTC P0565 is set, go to step 3 . If DTC P0565 is not set, go to next step.
- Using scan tool, check for DTC P0565 while performing following: Press cruise control main switch on for 3 seconds. With cruise control main switch on, press SET/COAST on for 3 seconds. With cruise control main switch on, press RES/ACCEL on for 3 seconds. If DTC P0565 sets, replace cruise control switch that sets DTC. If DTC P0565 does not set, problem is intermittent.
- Turn ignition off. Disable air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article. Remove and disconnect cruise control main switch. See CRUISE CONTROL FUNCTIONAL SWITCHES under REMOVAL & INSTALLATION. Start engine. Using scan tool, check for DTC P0565. If DTC P0565 is set, go to next step. If DTC P0565 is not set, replace cruise control main switch.
- Turn ignition off. Remove upper steering column should. Disconnect Black 4-pin connector from Supplemental Inflatable Restraint (SIR) coil assembly. Start engine. Using scan tool, check for DTC P0565. If DTC P0565 is not set, replace SIR coil assembly. See appropriate AIR BAG RESTRAINT SYSTEMS article. If DTC P0565 is set, check for short to power in Gray wire between PCM Black 28-pin connector terminal No. 3 and SIR coil assembly.